Before you start:
1. Read the instructions carefully.
2. Work over a sink or a surface covered in layers of newspaper (just in case).
3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out cartridges.
Even 30 minutes can ruin a cartridge if it dries out!
4. Have your printer manual handy for instructions on inserting a “new” cartridge.
BLACK CARTRIDGE
1. If necessary, use the tools provided to enlarge the filling hole situated on the top of the cartridge.
2. Fill the syringe with approximately 20ml of black ink.
 3. Push the syringe all the way into the filling hole and SLOWLY inject all the ink into the cartridge
or until the reservoir is full.
4. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
8. If necessary leave cartridge in printer for up to 24 hours. (This allows ink to flow to the print
head).
COLOUR CARTRIDGE
1. Locate the filler holes by removing the plastic top cover of the cartridge. You may need to pry
this off using a thin metal blade. Ensure you do not damage the sensors on the back of the cartridge
whilst doing this.
2. Using the picture, fill syringe with the corresponding colour ink.
3. Insert the syringe into the correct hole of the colour being filled and push all the way down.
You will feel resistance as there is a sponge inside. Slowly inject approximately 8ml of ink until
you can just see the ink surface on the top of the sponge, any more and it is over-filled. If this
happens simply draw back on the syringe a little.
4. Rinse the syringe and needle thoroughly before proceeding then repeat the process for the other
colours.
8. Re-attach the cover securely with adhesive tape and continue using the cartridge.
IMPORTANT – for best results, cartridge should be refilled whilst some
ink remains
Empty cartridges should be refilled immediately.
This work is best done over the sink.
|
