Before you start:

1. Read the instructions carefully.

2. Work over a sink or a surface covered in layers of newspaper (just in case).

3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out cartridges. Even 30 minutes can ruin a cartridge if it dries out!

4. Have your printer manual handy for instructions on inserting a “new” cartridge.

LC-21BK, LC-21C, LC-21M, LC-21Y

BLACK & COLOUR CARTRDIGES
1. Place a piece of tape over the outlet hole on the cartridge as shown in the picture.
2. Remove the cover using a small flat head screwdriver and carefully pry off the clip which holds the cover onto the cartridge.
3. Remove the large and small seals from the cartridge.
4. Using the drill or eyelet screw included, widen both the ‘Sponge’ and the ‘Auxiliary’ filling hole on the top of the cartridge.
5. Using the syringe filled with the correct colour ink for the cartridge you are refilling; insert the needle through the SPONGE filling hole and push it all the way into the cartridge.
You may feel slight pressure because the cartridge contains a sponge.
6. SLOWLY inject approximately 7ml of ink and reseal the SPONGE filling hole and breather port with some tape.
7. Insert the syringe into the AUXILLIARY filling hole no more than ¼” and inject approximately 3ml of ink and reseal with some tape.
8. To replace cover, snap it back onto the cartridge in the same direction it came off.
9. Unused ink may be returned to the bottle. Rinse syringe thoroughly and dry between colours and after use.
10. Remove the tape covering the OUTLET HOLE and reinsert the refilled cartridge(s). Run a priming cycle as per manufacturers’ instructions.

IMPORTANT – for best results, cartridge should be refilled whilst some ink remains
Empty cartridges should be refilled immediately.
This work is best done over the sink.