Before you start:
1. Read the instructions carefully.
2. Work over a sink or a surface covered in layers of newspaper (just in case).
3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out
cartridges. Even 30 minutes can ruin a cartridge if it dries out!
4. Have your printer manual handy for instructions on inserting a “new” cartridge.
 1. Using the screw provided, remove the plug(s) from the filler hole(s). Twist the screw into
the plugs and pull out or increase the size of the vent holes to fit the filling needle.
2. Insert the steel filling tube through the appropriate filling hole, (see diagram above) and
push into the cartridge. Continue pushing the steel filling tube until it reaches the other side
of the cartridge.
IMPORTANT – The cartridge contains a sponge and slight resistance may be felt.
3. SLOWLY inject approximately 20ml of ink (BC-01, BC-02, BX-02) or 7ml (BC-05) or until ink appears
at the filling hole.
4. If or when ink overflows from filling hole or starts to leak from outlet hole, the cartridge
is full. Stop injecting ink immediately
4. DO NOT reseal the filler holes.
5. Leave cartridge to stand overnight on a protective non-absorbent surface.
IMPORTANT:
For best results, cartridge should be refilled whilst some ink remains
Empty cartridges should be refilled immediately.
This work is best done over the sink.
|
