Before you start:

1. Read the instructions carefully.

2. Work over a sink or a surface covered in layers of newspaper (just in case).

3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out cartridges. Even 30 minutes can ruin a cartridge if it dries out!

4. Have your printer manual handy for instructions on inserting a “new” cartridge.

BC-20, BC-23 High Capacity

1. Carefully remove the plug on top of the cartridge using they eyelet screw provided. Keep it to re-seal the cartridge after filling.
2. Attach the needle to the syringe and fill with black ink.
3. Insert the syringe into the filling hole and push all the way into the cartridge. Note: The cartridge contains a sponge and slight resistance may be felt.
4. SLOWLY inject up to 30ml of ink into cartridge. When ink overflows from filling hole or starts to leak from outlet hole, cartridge is full. Replace the plug removed at the start.
5. Replace the cartridge and run a priming cycle as per the manufacturers instructions. You may need to leave the cartridge to stand overnight to allow the ink to fully soak into the sponge.

IMPORTANT – For best results, cartridge should be refilled whilst some ink remains.
Empty cartridges should be refilled immediately.
This work is best done over the sink.