Before you start:

1. Read the instructions carefully.

2. Work over a sink or a surface covered in layers of newspaper (just in case).

3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out cartridges. Even 30 minutes can ruin a cartridge if it dries out!

4. Have your printer manual handy for instructions on inserting a “new” cartridge.

BX-3

1. Make a 3mm hole using the drill bit supplied with the kit, make this about 10mm away from the edge. DO NOT TAMPER WITH THE SEALED FILLING HOLE.
2. Insert the black syringe into the newly made filling hole and SLOWLY inject about 20ml of ink. When ink overflows from filling hole, cartridge is full. Stop injecting immediately.
3. Seal the hole with the plug provided or strong tape. If the plug seal is not airtight then secure and seal plug with adhesive tape together.
THIS SEAL MUST BE AIRTIGHT, IF NOT CARTRIDGE WILL LEAK.
4. Leave cartridge to stand on a protective, non-absorbent surface overnight to ensure no leakage.
5. Install cartridge in printer and run a priming cycle as per printer instructions.

IMPORTANT – For best results, cartridge should be refilled whilst some ink remains.
Empty cartridges should be refilled immediately.
This work is best done over the sink.