Before you start:
1. Read the instructions carefully.
2. Work over a sink or a surface covered in layers of newspaper (just in case).
3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out
cartridges. Even 30 minutes can ruin a cartridge if it dries out!
4. Have your printer manual handy for instructions on inserting a “new” cartridge.
 1. Put the cartridge on some paper towels in an area where you can tolerate a spill.
2. Peal off the top label.
3. You will notice three small holes (too small for a syringe needle to get into). Drill each hole
larger with a thumb drill.
4. Fill the syringe with 6 ml. of colour ink ( Cyan, Yellow & Magenta).
5. Very SLOWLY & CAREFULLY inject ink into each chamber until the sponge full
6. When finished, replace the top label or cover with tape.
7. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
For best results,
leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
Note: Each time the cartridge is removed from the printer an "empty cartridge" message
appears and a blinking amber light will flash on the printer. Holding the paper feed button down
for 3-5 sec. will allow you to override the counter. IMPORTANT – For best results, cartridge
should be refilled whilst some ink remains.
Empty cartridges should be refilled immediately.
This work is best done over the sink.
|
