Before you
start:
1. Read the
instructions carefully.
2. Work over
a sink or a surface covered in layers of newspaper (just in
case).
3. Only re-fill
a cartridge that has just run out ~ this kit will not work
with old dried out cartridges. Even 30 minutes can ruin a cartridge if it dries out!
4. Have your
printer manual handy for instructions on inserting a “new” cartridge.
BLACK, COLOUR & PHOTO CARTRIDGES
In the picture shown, we have removed the label to help you identify where the filling holes are
located. However we DO NOT RECOMMEND YOU DO THIS.
 1.
Attach the needle to the syringe and identify the placement of the correct hole for the colour you are filling
based on the diagram right.
2. Once you have identified the correct filling hole for the colour and cartridge you are filling,
push the needle through the label into the cartridge. You will feel some resistance due to the
sponge inside, this is normal.
3. SLOWLY inject ink until the sponge is saturated (approximately 3ml ink).
4. Use adhesive tape to seal up the hole made in the cartridge label before continuing with other
colours to avoid contamination.
NOTE: The cartridge will leak if this is not done.
4. Once done, thoroughly rinse the syringe before using with any other colour inks.
5. Reinstall cartridge and run 1-3 test pages as per manufacturers instructions. IMPORTANT
We recommend refilling prior to the cartridge becoming empty.
Empty cartridges should be refilled immediately.
This work is best done over the sink.
|
