Before you start:

1. Read the instructions carefully.

2. Work over a sink or a surface covered in layers of newspaper (just in case).

3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out cartridges. Even 30 minutes can ruin a cartridge if it dries out!

4. Have your printer manual handy for instructions on inserting a “new” cartridge.

8R7994 - 8R7660
8R7661 - 8R7662 - 8R7663

1. With the drill bit supplied, make a 3mm filling hole above the ink reservoir (see diagram). IMPORTANT – DO NOT DRILL INTO THE SECTION CONTAINING THE SPONGE.
2. SLOWLY inject ink into the filling hole until the reservoir is almost full.
3. Seal the hole with the plug provided. If the plug seal is not airtight then secure and seal plug with strong adhesive tape.
THIS SEAL MUST BE AIRTIGHT, IF NOT THE CARTRIDGE WILL LEAK
4. Leave the cartridge to stand on a protective, non-absorbent surface overnight to prevent leakage.
5. Install cartridge in printer and run a priming cycle as per printer instructions.

IMPORTANT – For best results, cartridge should be refilled whilst some ink remains.
Empty cartridges should be refilled immediately.
This work is best done over the sink.